Teclock Measuring Stand for Durometer (GS Series)

Share:


Teclock Measuring Stand for Durometer (GS Series)

Measuring Stand for Durometer Hardness Tester GS series – Mechanical test stand for controlled test force by MSP Metrology (M) Sdn Bhd from Teclock Japan


Description


Automatic type Motor Driving Durometer Stand
  • Measured hardness only by operating switch.
  • Adopting stepping motor driving system
  • Alignment unit which realizes high
  • contact between indenter (contact point)
  • of durometer and test piece is mounted.
  • 1kg can be measured by type A and type E durometer as they are
  • Calibration certificate can be issued


Manual Operation type Durometer Stand with Speed Controller
  • Speed controller with high reliability Alignment unit which realizes high contact between indenter (contact point) of durometer and test piece is mounted.
  • 65mm for analog and 40mm for digital are obtained for possible measuring range.
  • Shaft with square thread is adopted that can prevent holder falling down and moving up and down.
  • 1kg can be measured by type A and type E durometer as they are.
  • Calibration certificate of mass (with durometer) can be issued


Manual Operation type Durometer Stand
  • Hardness can be measured by durometer with load prescribed by JIS by mounting durometer and manual operation.
  • Adopting cam has realized easy operation and cost performance.
  • Alignment unit which realizes high contact between indenter (contact point) of durometer and test piece is mounted.
  • 1kg can be measured by type A and type E durometer as they are.
  • Calibration certificate can be issued


 Inquiry - Teclock Measuring Stand for Durometer (GS Series)

GET IN TOUCH
10, Jalan Gemilang 9, Taman Perindustrian Cemerlang, 81800 Ulu Tiram, Johor, Malaysia.
+607-862 6772
STAY CONNECTED
LIKE & FOLLOW US