Aka-Cut cut-off wheels will perform at their very best together with Aka-Cool, an additive for recirculation units. Aka-Cool improves the cooling and lubricating ability of the water and acts as corrosion protection for both cut-off machine and sample material.

Aka-Cool is free from amine and boric acid, common in many other machine coolants. The absence of amines gives optimum skin compatibility with a pH of the mixed cooling fluid between 7 – 8, and an extremely low allergy potential.

The recommended mixing ratio of Aka-Cool in water is 3 – 5 %.

Aka-Cool guarantees a very long service life of the coolant and a safe and economical process flow.

Both in regards of cost and personal safety Aka-Cool is the optimal choice. When excessive foaming of the cooling water occurs, Aka-NoFoam is the solution.

Any formation of foam drastically reduces cooling of the sample during cutting and can result in thermal damage.

Aka-NoFoam eliminates foam and thus increases the cooling ability of the cooling water.

The recommended mixing ratio of Aka-NoFoam in the cooling fluid is 0.5 – 1 %.